Denon PMA-380 Instrucciones De Operación página 7

OPERATION
PREPARATION
1. CHECKING CONNECTIONS
e Make sure that all the connections are proper by referring
to the back panel. (Fig. 2~3)
@ Check the polarity (positive and negative) of connections,
and the directivity of stereo separation (right cord to right
channel terminal, and left cord to left channel terminal).
e@ Check the directivity of pin cord connection.
2. SETTING OF EACH KNOB
e Turn the volume control knob counterclockwise, to "0".
Set the rotary knob to "flat".
Set the TAPE MONITOR switch to "OFF."
Turn on the speaker selection switch for desired speaker
system (A or B).
After checking the above items, turn on the power, the amplifier is
set in the ready mode in a few seconds.
PLAYING A RECORD
1. Set the INPUT SELECTOR switch to "PHONO".
2. Operate the turntable and play the record.
3. Turn the volume and tone controls to yield an appropriate
volume and sound quality.
PLAYBACK OF CD PLAYER
1. Set the INPUT SELECTOR switch to "CD".
2. Operate the CD player.
3. Turn the volume and tone controls to yield an appropriate
volume and sound quality.
RECEPTION OF RADIO PROGRAMS
1. Set the INPUT SELECTOR switch to "TUNER".
_ 2. Operate the tuner to receive a radio program.
3. Turn the volume and tone controls to yield an appropriate
volume and sound quality.
1. Set the INPUT SELECTOR switch to "AUX" Position.
2. Operate the Audio equipment Systems.
ENGLISH
PLAYBACK WITH TAPE DECK
Set the TAPE MONITOR switch to "ON" and select "1 ( mt )" or "2
(== )" with the TAPE SELECTOR switch.
RECORDING WITH TAPE DECK
The source to be recorded is selected by the INPUT SELECTOR
switch.
While the tape is being copied, it is not possible to listen to
another program source from speakers.
e COPYING FROM ONE TAPE TO ANOTHER
To copy from tape deck 1 to 2, set INPUT SELECTOR switch to
"TAPE-1 » 2".
To copy from tape deck 2 to 1, set INPUT SELECTOR switch to
"TAPE-2 > 1".
e MONITORING THE RECORDING
A recording in progress can be monitored if a tape deck with
three individual heads for recording and playback is used. A
tape deck in which a common head is used for both recording
and playback cannot be used to monitor recording. Set the
TAPE SELECTOR switch to "1" or "2" to correspond to the
tape deck that is being used for the recording and set the TAPE
MONITOR switch to "ON". Use the TAPE MONITOR switch to
switch between the recording monitor and the program
source.
CAUTION
Protective Circuit
This set is equipped with a high speed protctive circuit. This
circuit protects the internal circuitry from damage due to
large currents flowing when the speaker jacks are not
completely connected or when an output is generated by a
short circuit. This protective circuit's operation cuts off the
output to the speakers. In such a case, be sure to turn the
power to the set off and check the connections to the
speakers. Then turn the power on again. After muting for
several seconds, the set will operate normally.