BIEMMEDUE SP 35 Manual De Instrucciones página 33

• Secure the burner plate to the machine by using the 4xM8 screws
and the D8 x D24 washers;
• Insert the burner and fix it to the plate by tightening the nut supplied
onto the screw G;
110 W LPG
• F
OR K MODEL ONLY
assembling the connection flange to the gas ramp as shown in the
following figure
• Be careful to correctly position the O-ring when fixing the
connection flange to the gas ramp.
• Locate the black cable with 7-pin Wieland plug running out of the
electrical panel and insert the plug into the socket H on the burner;
H
L-L 319.02-BM
G
: install the D 9.0 diaphragm before
EN
• Remove the burner cover and adjust the air pressure switch to the
value listed in the technical specifications table of the user manual;
• Adjust the gas pressure switch to 75% of its supply pressure
• Air pressure switch setting: 2 mbar
• Gas pressure switch setting: 75 % P
• Close the burner cover;
• Open the box containing the gas valve group and remove the valve
already secured onto a support plate
• Secure the gas valve group to the machine using the M8 and M5
screws.
• Connect the stainless steel hose to the burner, taking care to
properly insert the N gas seal:
• Locate the cable with 6-pin Wieland plug running out of the gas
valve group and insert the plug into the burner socket;
• Apply one of the two stickers with the serial number on the
nameplate of the machine characteristic data:
• Apply the second sticker with the serial number on the Assembly
and Installation Declaration contained in the user manual:
IN
N
33 / 64