Worx WG712 Manual Del Usuario página 9

®
®
AS$EMBLY
//_ impoi'_nt w .
Before you assemble the lawn mower,
check the packing fist on page 5, Make sure a!l
parts are included.
FJITTgNG THE LO_R HANDLE
(See A, B, C, D)
When removed from the box, the mower should
now look like fig AmFix the lower ha ndle brackets
(17) to the deck as fig B and align the handle as
fig C, Make sure that they are located properly
before inserting the lower handle knobs and
tighten clockwise.(See D) Lift the Upper handle
into position as shown in E,, Align handle and
tighten handle knob clockwise. Check that the
upper and lower handles are firmly secure,,
Ensure the cables do not become stuck when
foldinglunfolding Lower Handle
Note: Ensure that the cable clips (14)(See E)
supplied are used to fix the cable to the Lower
Handle (15)o(See B) Attach the cable clips and
make sure there is enough cable slack,,
G_u_SSBOX ASSEMBLY
(See F.t )
DO NOT OVERTIGHTENTHE SCREWS°
First connect the grass box handle (10) to the box
top using the four provided screws
Grassbox ASSEMBLY (See E2 and G )
Next, snap together the top and bottom grass
box halves by pushing all the "snap fits" together
around the edges; start from the rear and work
towards the front°
GRASSBOX
Fitting
Lift the safety flap (9) and insert grass box
(8)o(See H)
As the grassbox fills up, grass will be clearly
visible through the inspection window(18)(See
I)
When the window is futl it its time to empty the
grassbox,
Removing/Emptying
Lift the safety flap (9) and hold up. Remove
grass box (8)°
MULCHING FEATURE
The mower is designed to mulch the grass
depending on whether mulching insert
(t9) is inserted (mulching) or the mulching
insert is out and the grassbox is in place ,, No
further assembly steps are required if you are
mulching_
1, Unplug mower, and wait for blade to come
to a complete stop,,
2., Raise the safety flap (9) and hold it up (See
H2)
3,, Lift and push in the mulching insert
completely(See H,3)
For non-grass collection, the mower can be
used without the grass box (8) in position, with
the safety flap (9) in the down position,,
'W'X_ W'arning: Always check the safety flap
can close the discharge outlet tightly
before using, Never lift the safety flap (9) when
the lawn mower is being used without fitted
grass box°
8P :RATISN
STARTING AND STOPPRNG (See J)
STARTING
Connect the extension cord to the pigtail (See
J),Connect the plug to the power outlet and
switch ON_
The switchbox is provided with a lock-off button
to prevent accidental starting.
Press and hold the safety button (2)_ with
the other hand, squeeze the switch lever (1)
towards the handle,and release the safety lock
off buttonoThe machine is now started. Wait
until the blade is at full speed before cutting the
grass.
Use both hands to hold the switch lever to keep
the mower running°
STOPPING
Release the switch lever (1).
ADJUSTgNG THE CUTTING HEIGHT
(See iO
_ Warnlng: Before adjusting the
mower height, wait for the mower to
completely stop. Mower blades continue
to rotate after the machine is switched
off and a rotating blade can cause injury.
Wait until all machine components haue
o9
®
NAoWG712_M_070115, indd 9 2007-1q5 16:53:00