MR TAPCON 230 Manual página 15

1 Key without function if a digital input is used to toggle between LOCAL/REMOTE.
2 Only possible in manual mode.
– Technical documents
– Additional nameplate
– Terminating resistor for CAN bus
– Terminating resistor for RS485 bus
Optional
– Housing for wall mounting
– Device type-dependent:
– Ethernet to FO converter (SFP module)
– Serial to FO converter
4.3 Design
4.3.1 Display, operating elements and front interface
Figure 2: Voltage regulator
1 REMOTE key
2 AUTO key
2
3 RAISE key
4 MANUAL key
5 LOWER key
6 Display
7 Front interface
8 ENTER key
9 LEFT cursor
10 RIGHT cursor
11 BACK key
1
Activate REMOTE mode
Activate AUTO mode
Send a control command to the motor-drive
unit to increase the voltage.
Activate MANUAL mode
2
Send a control command to the motor-drive
unit to reduce the voltage.
-
RJ45 Ethernet interface
Confirm selection/save modified parameters
Navigate to the left in the menu
Navigate to the right in the menu
Exit the current menu. Return to the previ-
ous menu level
7820658/06 EN Product description
15