MR TAPCON 230 Manual página 39

Miniature circuit breaker You must fuse the power supply circuit with a miniature circuit breaker. The
Conductor cross-section For the power supply circuit, use a conductor cross-section suitable for the
5.4.12.2 Connecting to ground
miniature circuit breaker must have the following properties:
– Rated current: 6...10 A
– Triggering characteristic: C, K or Z
miniature circuit breaker that you have selected, but at least 1.5 mm
Connecting the power supply
Connect the power supply in accordance with the connection diagram
[►Section 8.14, Page 59] and ground the device.
1. Remove the nut and washer from the grounding screw.
2. Attach the grounding cable and the power supply cable grounding wire to
the grounding screw of the device and secure them using the nut and
washer.
Figure 38: Grounding cable connection
2
(AWG 15).
7820658/06 EN Mounting
39