MR TAPCON 230 Manual página 24

24
Mounting 7820658/06 EN
4. Screw the threaded pins into the tension clamps and secure the device.
Figure 16: Securing the device
The device is mounted and can be wired up.
5.3.2 Wall mounting with housing (optional)
For wall mounting, the device is fixed to the wall in a housing using wall brack-
ets. Use the supplied tension clamps to install the device in the housing.
5.3.2.1 Drill holes for wall mounting
Drill 4 holes, each 6.8 mm in diameter, in the wall as shown in the drilling tem-
plate below.
Figure 17: Drilling template for the housing
5.3.2.2 Affixing the housing to the wall
The screws for wall mounting are not included in the scope of supply. The
i
screw length required depends on the wall thickness.
444,3 mm (17,49 in)