MR TAPCON 230 Manual página 55

Interface
Table 29: Connector X4 (group 3)
8.10 Communication interfaces
Description
Interfaces
COM X1
Only available for the
TAPCON® 230 Pro, Expert and AVT
variants.
COM X2
COM X3
Only available for the
TAPCON® 230 Expert and AVT vari-
ants.
COM X4
Only available for the
TAPCON® 230 Expert and AVT vari-
ants.
COM X5
Only available for the
TAPCON® 230 Expert and AVT vari-
ants.
COM-X6
Only available for the
TAPCON® 230 Pro, Expert and AVT
variants.
Pin Description
4 V3 U- voltage input
4
3 V3 I- current input
3
2 V3 I+ current output
2
1 1 V3 U+ voltage output
Assembly for converting interfaces and media
1x RS232/RS485 (RJ45): COM X1
2x Ethernet (RJ45): COM X2, COM X5
1x RS232 (D-SUB): COM X3
1x duplex LC (SFP): COM X4
1x plug terminal 10-pin: COM X6
Internal system interface for connecting the COM
X6 interface to the central processing unit (CPU)
Internal system interface for connection the front
interface to the central processing unit (CPU)
Serial SCADA interface RS232
– 9-pin D-SUB connector
SFP module for converting Ethernet (RJ45) to fiber-
optic cable for SCADA
– Max. 2000 m
– 100 Mbps
– Light-emitting diode: class 1
– Wave length: 1310 nm
– Max. optical output power: <1 mW (in accor-
dance with IEC 60825-1:2014)
Ethernet connection for SCADA
10-pin plug terminal
– Tap position capture via resistor contact series
– CAN bus
– Serial SCADA interface RS485
– Electrically isolated
7820658/06 EN Technical data
55