Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION! Danger of crushing your hand!!
Emergency stop!
Attention! Hot surface can cause burns!
Always disconnect the device from the power source after finishing your work.
Do not wear loose clothes that can get caught in the moving parts of the machine. Wear close-
fitting clothing.
Do not use gloves when working with the device.
ATTENTION! The figures in this manual are illustrative only and may vary in some details from
the actual appearance of the product.
2. Safety of use
ATTENTION!
Read all safety warnings and instructions. Failure to follow the warnings and
instructions may result in electric shock, fire, and/or serious injury or death.
The term "device" or "product" in the warnings and the description of the instructions refers to
Pellet mill
2.1.
Electrical safety
a)
The plug of this device must fit into the outlet. Do not modify the plug in any way. Original plugs and
matching outlets reduce the risk of electric shock.
b)
Avoid touching grounded parts, such as pipes, heaters, ovens, and refrigerators. There is an increased
risk of electric shock if your body is grounded and touches the device while exposed to direct rain, wet
pavement, or while working in a damp environment. If water enters the device, there is an increased
risk of damage to the unit and electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Do not use the cord in an unintended manner. Never use it to carry the device or to pull the plug out
of the socket. Keep the cord away from heat sources, oil, sharp edges, or moving parts. Damaged or
tangled cords increase the risk of electric shock.
e)
When operating the product outdoors, use an extension cord designed for outdoor use. Using an
extension cord designed for outdoor use reduces the risk of electric shock.
f)
If you cannot avoid using the product in a wet environment, use a residual current device (RCD) to
connect the product to electrical mains. Using an RCD reduces the risk of electric shock.
g)
Do not use the device if the power cord is damaged or shows signs of wear. A damaged power cord
should be replaced by a qualified electrician or the manufacturer's service department.
h)
To avoid electric shock, do not immerse the cable, plug, or the device itself in water or other liquid.
Do not use the appliance on wet surfaces.
i)
CAUTION – DANGER TO LIFE! When cleaning or using the appliance, never immerse it in water or
other liquids.
j)
Do not use the appliance in rooms with very high humidity / in the immediate vicinity of water tanks!
k)
Do not allow the machine to get wet. Risk of electric shock!
l)
The electric connection should be made by a qualified electrician.
EN
Publicidad
