Publicidad
Idiomas disponibles
Idiomas disponibles
Dispenser couldn't get
cooling water
The water is not cooled
enough
Dispenser couldn't
get ice
The cubed ice or
water is too small
Failing to access the water source
or open the water valve
The filter is not installed correctly
The water valve or connectors are
not installed correctly
The fridge temperature is set too high
Take too much water in one time (1L)
Take the water so often
No ice inside the storage box
Failing to access the water source or
open the water valve
The "ice off" mode is working, it will
stop making ice
The pressure of water source is not
enough
The water valve or connectors are
not installed correctly
The filter is not installed correctly
The ice cubes are frozen together in
the storage box to block the ice outlet
There is something hard in the
storage box, which prevents the
motor from running
The doors is not closed totally which
will make the cold air leak out
The pressure of water source is not
enough
The water filter is blocked, because
it has been used too long time
The water flow meter is fault
Make sure the water source and the
valve is open
Check whether the filter direction is
reversed
Check whether water valve or
connectors are reversed
Set the fridge temperature lower
Wait for the water cool down
Wait for the water cool down
Wait for the ice maker to finish making
ice (the first time on the refrigerator
needs to be fully cooled, the ice maker
will start making ice);
Make sure the water source and the
valve is open
Turn off the "ice off " mode
Ensure the source water pressure is
1.5 ~ 7 bar
Check whether water valve or
connectors are reversed
Check whether the filter direction is
reversed
Remove the frozen ice cubes
Remove the thing which blocks the outlet
Ensure the doors is closed totally
Ensure the source water pressure is
1.5 ~ 7 bar
Replace a new water filter
Contact maintenance personnel
30
Publicidad
