Greencut GX12000i Manual De Instrucciones página 54

54
ASSEMBLY
• Place the axle rod of the wheels on the rear base of the generator. Use the screws and nuts included for this
purpose (4 M8x25 screws + 4 M8 nuts).
• Insert a wheel on each side of the shaft, and place the safety pin in the hole for that purpose (two flexible pins
are included).
• Attach the supports on the front base of the generator. Use the screws and nuts included for this purpose (4
M8x25 screws + 4 M8 nuts).
USING THE PRODUCT
BEFORE USING THE PRODUCT
FUEL
WARNINGS
• Read the safety section on the use of fuels carefully.
• Use 95 octane unleaded gasoline.
• Always avoid your eyes to get into contact with fuel or oil. If fuel or oil comes into contact with your eyes, wash
them with clean water immediately. If you feel your eyes irritated, consult a doctor immediately.
• Do not use fuel that has been stored for more than a month. Fuel stored for too long will make it harder to start
the machine and will produce unsatisfactory engine performance. If fuel has been in the machine tank for more
than a month, remove it from the machine and replace it with one in perfect condition.
• Stop the engine before refuelling.
• Do not refuel in places where there are flames, sparks or intense sources of heat. Always fill the tank with the
engine stopped and in well-ventilated areas. Do not overflow the fuel tank by trying to overfill it with fuel. In case
of fuel spillage ensure to eliminate the spillage completely before starting the engine. Move the machine away
from the spill area and avoid any source of ignition until the fumes have dissipated.
• Move at least 3 meters away from the area where you refuelled before starting the machine.
• Add fuel before starting the machine. Never remove the fuel filler cap while the engine is running or when the
machine is hot.
• Do not use fuels such as ethanol or methanol. These type of fuels will damage the engine.
FILLING UP THE FUEL TANK
• Choose a suitable area to perform this operation.
• Remove the fuel filler cap and refill with the indicated fuel.
• Re-install the fuel tank cap tightly and wipe away any fuel that may have spilled on the outside using a dry cloth.
ENGINE OIL
The engine of your machine comes from the factory without oil for transport reasons. Before starting the engine for
the first time it is necessary to add oil to the engine. This engine uses quality oil for 4-stroke engines. The engine
crankcase capacity is indicated in the Technical Data section.