Greencut GX12000i Manual De Instrucciones página 60

60
If the engine does not work properly (lack of power, unstable idle, etc ...) please find below some of the possible
symptoms, the possible cause and solution:
PROBLEM
The machine chimes
Engine overheats
Engine stumbles
The engine stops or does
not idle
NOTE: In the case of not being able to solve the problem, take your machine to the technical
service.
TRANSPORTATION AND STORAGE
TRANSPORT
• Wait 5 minutes after the machine has been switched off to cool it before storing or transporting it.
• If you are going to transport the machine in a vehicle, secure it firmly to prevent it from sliding or tipping over.
• Consult the weight of the machine in the technical data section. To lift it, use the handle.
• Always transport the machine horizontally.
STORAGE
• Do not store the machine near flammable materials (dry grass, wood ...), gas or fuels.
• Store this tool in a safe place and out of reach of children so that it does not endanger anyone. Store the machine in
a dry, clean place and at a temperature between 0ºC and 45ºC.
• Please check and follow the maintenance program before storing the machine.
• Always clean the machine before storage, and be placed on a flat surface.
• If you store the machine indoors, empty the fuel as the fumes could get into contact with naked flames or heat and
ignite.
POSSIBLE CAUSE
Worn segments
Used piston
Crankcase lose
Clutch lose
Dirty exhaust
Wrong fuel type
Carburettor is dirty
Dirty air filter
Dirty fuel filter
Carburettor not set properly
SOLUTION
Take your machine to the Official Service
Take your machine to the Official Service
Take your machine to the Official Service
Take your machine to the Official Service
Take your machine to the Official Service
Replace fuel
Take your machine to the Official Service
Clean the filter
Clean the filter
Take your machine to the Official Service