Publicidad
Idiomas disponibles
Idiomas disponibles
Disconnect battery pack from tool before making any assembly, adjust-
ments or changing accessories. Such preventive safety measures reduce
the risk of starting the tool accidentally.
Inserting and Removing
Battery Pack
Use only Bosch or AMP-
Share batteries recom-
mended in the battery/charger list, included
with your tool. Use of any other types of bat-
teries may result in personal injury or property
damage.
Ensure the switch is in
the off position before in-
serting battery pack. Inserting the battery
pack into power tools that have the switch
ON invites accidents.
(Fig. 1, 3, 4)
To insert the battery pack:
1. Set Forward/Reversing Lever and Trigger
Lock 11 to the locked position (Fig. 1).
2. Slide charged Battery Pack 8 into the
housing until the battery pack locks into
position (Fig. 3).
Your tool is equipped with a secondary lock-
ing latch to prevent the battery pack from
completely falling out of the handle, should
it become loose due to vibration.
To remove the battery pack:
1. Press the Battery Pack Release Button
9 and slide the Battery Pack 8 from the
housing (Fig. 4).
2. Press the Battery Pack Release Button 9
again and slide the Battery Pack 8 com-
pletely out of tool housing (Fig. 4).
Mounting and Removing Adapters
(Fig. 5, 6)
1
Make sure that there are no screwdriver
or drill bits in the main Hex Drive 1 (Fig.
2
5). To remove a bit, push Locking Sleeve
1
2 back and pull the bit out.
3
2
Insert the hex shaft of an adapter into the
4
Hex Drive 1 and push the adapter, turning
3
it clockwise and counterclockwise, until
there is no gap between the clutch ring
4
and the locking ring on the adapter, and
the adapter snaps in place.
14
2610070415 GSR18V800FC 202310.indd 14
page heading
Assembly
Fig. 3
(8)
Fig. 4
(9)
Fig. 5
(1)
2
1
3
(17)
(2)
10/24/23 3:15 PM
Publicidad
