Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the Drilling Depth
(GFA18-H Hammer Adapter – Sold
separately)
(Fig. 14)
The desired drilling depth X can be specified
with the depth stop.
1
Insert the SDS drilling bit into the Hammer
Adapter, see "Inserting and Removing SDS
2
Bits" on page See "Inserting and Remov-
ing SDS Bits (GFA18-H Hammer Adapter
3
1
– Sold separately)" on page 17.
2
4
Press the Depth Stop Locking Tab 20,
1
located on the outside of the depth stop
3
holder, to allow movement of the of the
2
depth stop in the holder.
4
3
While pressing the locking tab, move the
depth holder until the tip of the depth
4
stop is placed behind the tip of the bit,
and the distance between the two tips is
equal to the desired drilling depth "X" as
shown in Fig. 14.
Belt Clip
When the tool is attached
to the belt, position your-
self to avoid entanglement with surround-
ing objects. Unexpected entanglement could
cause the tool to fall resulting in injury to the
operator or bystanders.
(Fig. 1)
The Belt Clip 7 will allow you to conveniently
attach your tool to your belt (Fig. 1). This fea-
ture will allow you to have both hands free
when climbing a ladder or moving to another
work area.
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use.
To use clip, turn tool upside down and attach
to your belt.
18
2610070415 GSR18V800FC 202310.indd 18
page heading
Assembly
Fig. 14
1
4X Bit Tip Holder
bits could interfere with proper tool opera-
tion and result in user injury.
(Fig. 15)
The four piece Bit Tip Holder 6 can be used
for convenient on tool storage of your most
commonly used bits.
When mounting bit holder accessory, mount
on the side of the drill opposite the belt clip.
Always make sure you securely tighten the
mounting screw before use.
2
20
3
X
(6)
Store only bit tips in the
on-tool bit holder. Longer
Fig. 15
10/24/23 3:15 PM
Publicidad
