Publicidad
Idiomas disponibles
Idiomas disponibles
Variable Speed Controlled
Trigger Switch
(Fig. 1)
Your tool is equipped with a Variable Speed
Trigger Switch 12. The tool can be turned
"ON" or "OFF" by squeezing or releasing the
trigger. The speed can be adjusted from the
minimum to maximum nameplate RPM by the
pressure you apply to the trigger. Apply more
pressure to increase the speed and release
pressure to decrease speed.
Forward/Reversing Lever &
Trigger Lock
(Fig. 17)
After tool use, lock trig-
ger in "OFF" position to
help prevent accidental starts and acciden-
tal discharge.
Do not change direction
of rotation until the tool
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
Your tool is equipped with a Forward/Re-
versing Lever and Trigger Lock 11 located
above the trigger. This lever was designed for
changing direction of rotation of the bit, and
for locking the trigger in an "OFF" position.
For forward rotation, (with chuck pointed
away from you) move the lever to the far left.
For reverse rotation, move the lever to the
far right.
To activate trigger lock, move lever to the
center off position.
20
2610070415 GSR18V800FC 202310.indd 20
Operating Instructions
page heading
Fig. 17
(11)
(11)
10/24/23 3:15 PM
Publicidad
