Publicidad
Idiomas disponibles
Idiomas disponibles
◾
To stop or decrease speed, release the accelerator pedal slowly.
NOTE: When the accelerator pedal is released the tractor will not continue to coast like a typical gas-powered car.
Instead, the electric brake will be applied and the tractor will stop abruptly.
◾
To increase speed, depress the accelerator pedal all the way. The harder the accelerator pedal is depressed, the
faster the tractor will travel.
DANGER: Stay at least two mowing widths (7 ft /2.13 m) away from any ditches, drop-offs, or water. Front wheels
can rotate when the tractor is stopped, even with the brake applied, and cause the tractor to go over the edge or into the
water and result in death or serious personal injury.
WARNING: Be aware of what is behind the tractor before backing up. DO NOT mow in reverse unless absolutely
necessary. Always look down and behind before and while backing to make sure no children, bystanders, or pets enter
the mowing area. Remember that a careless fraction of a second is sufficient to inflict death or serious injury.
WARNING: Be certain you have correctly set your intended direction of driving with the steering wheel before
depressing the accelerator pedal. Failure to do so could result in you driving the tractor in an unintended direction, which
could cause loss of control or an accident.
WARNING: Be cautious when crossing over gravel paths or driveways. Before crossing, turn off the blade motors and
raise the cutting deck to the highest position to minimize the possibility of ricochet. Drive slowly to avoid loss of traction
and control.
CUSTOMIZING MOWING AND DRIVING SETTINGS (Fig. 19)
For the best mowing experience, we recommend customizing the following settings
depending on your situation.
NOTE: The electric lawn tractor does not memorize the driving speed and blade
speed settings. The driving speed and blade speed will return to level 2 every time
the tractor is turned off.
To Select Your Driving Speed Level (Fig. 19a):
The driving speed level establishes the maximum driving speed of the tractor.
Level 1 (Low speed): for low-speed edging and trimming, or when mowing or
driving in tight areas.
Level 2 (Standard speed): offers the best balance between cut quality and run time.
Level 3 (Max speed): maximize the coverage area when mowing large, flat lawns.
Press the driving speed adjustment button to toggle among above speed levels.
NOTE: Higher driving speed will increase coverage.
44
56-VOLT LITHIUM-ION ELECTRIC LAWN TRACTOR — TR4200/TR4200-FC
19a
Level 3
Level 2
Level 1
Driving Speed
Adjustment Button
Publicidad
