Publicidad
Idiomas disponibles
Idiomas disponibles
Important Tips
Audio Signal for Indication of the Laser Beam
ƒ The position of the laser beam on the reception area
can be indicated via an audio signal.
ƒ The volume level can be increased, decreased
or switched OFF.
ƒ At low volume level, the Audio Signal Indicator
appears on the display with one bar.
ƒ At high volume level, the Audio Signal Indicator
appears on the display with two bars.
ƒ When the audio signal is turned OFF, the volume indicator
cannot be seen.
ƒ Independent of the audio signal setting, a short, low-volume
beep sounds every time a button on the receiver is pressed.
Fine/Coarse Adjustment
ƒ Accuracy will always default to fine setting when
powered-ON.
ƒ Press the Accuracy Button
setting.
ƒ Pressing the Accuracy Button
to fine setting.
NOTE:
Course setting allows faster detection and centering of
the laser beam.
Detecting the Laser Beam
ƒ The position of the laser beam on the LED display
is indicated by:
- Audio and directional indicators
- Optionally via the directional signal only
18
once to switch to coarse
18
again will switch back
28
17
17
Publicidad
