Equipment Regulations; Starting - Lincar Betty 531 Manual Del Usuario - Mantenimiento

EQUIPMENT REGULATION
REGULATION Room Temperature
To set up the room temperature means to keep a limit on
equipment heating, if the room temperature overcome
the set up value ( ex.20°) the equipment will
automatically reduce the power putting it to minimal
power ( power 1) to avoid waste of combustible. .
- On the display push P1 or P2
- Regulate the power required with P1 and P2
- When the regulation of room temperature is finished, push briefly P3 and the new
temperature will be memorized, the display will return on previous page.
REGULATION Equipment Power.
The equipment can be regulated on 5 power levels. (1-min , 5-max). We recommend the
power 3 for the first functioning hours.
The equipment will employ the set up value as maximal value for the heating functioning, it's
possible in this way to limit the max equipment power.
Anyway, if the room temperature will reach the programming
value, the equipment will reduce automatically the power
(modulation) to avoid waste of combustible.
- In the first display/page push P5 and P6
- To regulate the installation power employing P5 or P6.
- When the regulation of equipment power is finished, push
briefly P3 and the new temperature will be memorized, the display will return on previous
page.
STARTING CYCLE
1° Light On (new equipment or every time that the tank is empty of combustible)
- Put the fuel into the container and switch on the appliance
-In case the display is signalling an alarm keep the push button
P4 pressed
-In case the display is signalling "Final cleaning" wait until on
the display appears "Off" (approx. 15 minutes)
- Appliance in switched off condition display "OFF
- Push on P3 to get access to the program menu.
- Push P5 or P6 to go on MENU 07
- Push P3 to go to the menu load initial
- Push P1 to activate the start of 90 seconds of screw feeder
- Once the pellet has started to fall into the burner basket press
on push button P4 to stop the fall of fuel into the burner basket.
If necessary, repeat this operation several time just when the
pellet fall down in the burner basket.
46/124
IT IT IT IT- - - - GB GB- - - - FR FR- - - - E E E E S S S S mod. 531 – 531N
GB GB FR FR