Installation Instructions
INSTALLATION—VENTED TO THE OUTSIDE
INSTALL HOOD MOUNTING SCREWS
The two upper mounting screws must enter the horizontal
support or wall studs.
With the template taped in place, use a punch to mark
mounting bracket screw locations.
* Drill 1/8" pilot holes in 2 of the punched locations
in the lower bracket.
« Remove the template.
* Install the mounting screws, leave 1/4" gap between
the screw head and the wall. This will allow the keyhole slot
on the hood frame to engage the screw head.
IMPORTANT: Use the mounting screws provided. DO NOT USE
DRYWALL SCREWS.
¢ Check to be sure the mounting screws are
horizontally level.
INSTALL DUCT BRACKET
The duct bracket should be installed against the back wall
and flush with the ceiling. This bracket will hold the duct cover
in place at the top.
Secure the bracket to the wall:
¢ Align the diamond centerline cutout on the bracket
with the penciled centerline on the wall.
* Mark 2 screw hole locations in the wall.
* Drill 1/8" pilot holes in the marked locations.
* If pilot holes do not enter wood studs, enlarge the holes
to 3/8" and install metal wall fastener anchors (provided).
« If mounting directly to a masonry wall, obtain appropriate
#10 masonry screw anchors. Drill and install per the
fastener supplier's instructions.
* Drive screws, by hand, into the fasteners to allow anchors
to expand. Remove the screws.
* Secure the bracket to the wall with wood screws and/or fasteners.
\
G
Centerline cutout
10
MOUNT THE HOOD
WARN
| NG: 2 people are required to lift and position
the hood onto the mounting screws.
* Lift the hood onto the mounting screws.
Check level and mark bottom screw locations.
* Remove the hood.
* Drill 1/8" pilot holes in the marked location.
* If pilot holes do not enter studs, enlarge the holes to 3/8"
and install metal wall fastener anchors (provided.
* Lift the hood onto the mounting screws.
¢ Install lower screws to pull the hood tight against the wall.
* Tighten the top mounting screws.
Tighten
screws
7
O02 OOO
Install
screws