Monogram Z2V830 Instrucciones De Instalación página 13

Installation Instructions
INSTALLATION—VENTED TO THE OUTSIDE
INSTALL FILTERS
IMPORTANT: Check to be sure that the main ON/OFF
switch next to the motor is in the ON position.
/ — 00000 — \
Push-button
switch
(horizontal
view from
inside
opening)
* Remove protective films on the grease filters and
filter cover panel.
NOTE: The charcoal filter is not required for this
installation.
i L
[ = Ooo006 a \
* Tip the filter into the left or right side of
the opening. Lift the filter to the opposite
side and into the filter lock.
* To remove the filter, push the latch toward
the center and pull downward.
/[ Ooo O60 — \
* To close the filter cover panel, push up on both
sides at the front corners to engage the latch.
13
[9] FINALIZE INSTALLATION
¢ Check to be sure all tape and packaging materials
have been removed.
* Refer to the Owner's Manual for operating
instructions.