Monogram Z2V830 Instrucciones De Instalación página 6

Installation Preparation
TOOLS AND MATERIALS REQUIRED Ee
(NOT SUPPLIED)
ee
Oo Tape measure —<2 ee Gloves
Oo Knife ..
CO Spirit level Spirit level
O Wire cutter/strioper Measuring tape
HO Wire nuts
O Electric drill with 1/8" and 3/8" bits ——
0 Phillips and flat blade screwdrivers \ YS aN
CO Hammer
,
(i
Ga iN
A Phers Pliers Electric drill YY
t) with 1/8" and Wire
0 Safety glasses
DO Aluminized duct tape
FH Tape to mount template
FO Gloves to protect against sharp edges Aluminized —,)
FH 120V 60Hz. 15 or 20 Amp, 2 wire with duct tape ey
ground Properly grounded branch circuit
OD Strain relief for junction cover S Hammer
0 8" round metal duct, length to suit O5 =
installation ; " ar
0 Saw, jig saw or reciprocating saw Strain relief Prilh —
HO Tin snips __ = head" Flat blade
a2 ()=0
;
screwdriver
screwdriver
Wire nuts
eh
Saw, jig saw or
Masking tape reciprocating 8" round metal duct,
oo
saw
length to suit
Tin snips
installation
REMOVE THE PACKAGING
CAUTION: wear gloves to protect against
sharp edges.
¢ Remove duct covers.
« Remove the parts box and other pieces. Locate
the literature package.
« Remove and properly discard the protective plastic
wrapping and other packaging materials.