Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
INSTALLATION—RECIRCULATING
INSTALL FILTERS
[9] FINALIZE INSTALLATION
IMPORTANT: Check to be sure that the main ON/OFF
* Remove alll tape and packing material.
switch next to the motor is in the ON position.
° Refer e the Owner's Manual for operating
1
:
INSTTUCTIONS.
Push-button
switch
(horizontal
view from
inside
|
opening)
* Remove protective films on the grease filters and
filter cover panel.
Insert the black charcoal filter into the opening.
Push the latch on both sides toward the center
and engage the flange. Release latches to secure.
[
a
oco06G
a
\
* To remove the filter, push the latches toward
the center and pull downward.
* Install the metal grease filter into the hood
support channels directly below the charcoal
filter.
[
-
e090 000
—_
\
NOTE: The charcoal filter should not be used
without the metal filter secured below.
* To close the filter cover panel, push up on both
sides at the front corners to engage the latch.
18
Publicidad
