ADE WS 2301 Instrucciones De Operación página 56

‚ The weather data received by the wireless outdoor
sensor will appear on the display after a short time.
From now on, this data will be transmitted several
times a minute and constantly updated.
‚ The indoor temperature and humidity readings from the
base station are displayed in the bottom right corner.
‚ As soon as the signal from the time signal transmit-
ter has been received with sufficient strength, the
corresponding data and the radio tower symbol are
shown permanently on the display. This process can
last a few minutes.
From now on, the weather station automatically switches
to receiving-mode multiple times each night. During
this process, the displayed time is compared with that
received from the time signal transmitter and, if necessary,
corrected.
If no sufficiently strong signal has been received, the
base station aborts the receiving process after a few min-
utes and the radio-tower symbol goes out. The receiving
process is started again at a later point in time.
In this case, the time proceeds as usual (beginning with
the start time of "00:00").
Checklist when data is missing on the
display
No data display from the time signal transmitter
1. Check whether the location of the base station is
suitable; see "Choosing a location".
56
Weather station with wireless outdoor sensor WS 2301