Descargar Imprimir esta página

Coway Airmega 160 Manual Del Usuario página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

ADJUST PARTICLE SENSOR
How to adjust the sensitivity of the air quality sensor
When the product is shipped out, the air quality sensor is set to standard sensitivity. Users can change the
sensitivity of the air quality sensor as follows if the pollution level remains at the highest level after 2 hours
of operation or stays at the lowest level for more than 1 hour when the air does not appear clean.
1. While the product is operating, press the power
button and the speed button at the same time for
more than 2 seconds.
2. The speed indicator flashes at an approximately
0.5 second interval.
3. Press the speed button to adjust to the desired
sensitivity.The speed indicator blinks as shown below
once sensor sensitivity has been selected.
Level 1
High
Standard
4. Press the Power and the Speed button together for
more than 2 seconds. The selected sensitivity will
be inputted, and the product will start operating
normally.
∗ If the power button and the speed button are not pressed for 10
seconds,the selected sensitivity of the sensor is automatically entered.
Level 2
Level 3
Low
2 sec.
2 sec.
Flash
Flash
2 sec.
2 sec.
13
14

Publicidad

loading

Este manual también es adecuado para:

Airmega 160nAirmega 160w