Impecca RA-2070 Manual De Usuario página 5

UNIT OVERVIEW AND FEATURES
1
2
3
4
5
1. Freezer Shelf
2. Thermostat and Light
3. Glass Shelves
The images in this instruction manual are for illustrative
purposes. The physical appearance and options on your
particular model may vary. In addition, your appliance
may ship with an ice cube tray.
Carefully remove all packaging material. This includes the
foam base and all adhesive tape holding the refrigerator ac-
cessories inside and outside. Inspect and remove any remains
of packing, tape or printed materials before powering on the
refrigerator.
6
4. Crisper Cover
5. Crisper
6. Balconies
–5–
INITIAL OPERATION
Clean the unit before first use (see the next section for clean-
ing instructions). After cleaning, plug the unit into its power
source. Do not turn on the unit if it has been moved within the
past 2 hours, as the coolant fluid needs time to settle.
The thermostat control knob for the refrigerator and the chiller
is located near the chiller compartment (see picture to the left).
The first time you turn the unit on, adjust
the thermostat control knob to the middle
setting and give your refrigerator time to
cool down completely before adding food;
a full 24 hours is recommended.
After it is fully cooled, adjust the knob to best suit your needs.
"1" is the least cool and "7" is the coolest setting. However, a
setting of "3" should be appropriate for most home or office
refrigerator use. Warmer environments may be more likely to
require higher settings (4 or 5). Cooler or winter environments
are likely to use a lower setting.
NOTE: Turning the thermostat control knob to the "0" or
"OFF" position will stop the cooling cycle but does not shut
off the power to the unit.