Publicidad
Idiomas disponibles
Idiomas disponibles
447Wa Nesting Trio — Parts List (cont.)
BEFORE BEGINNING ASSEMBLY
,
check that the quantities of the parts received match those on the parts list below.
Ma — Large Back Stretcher — Qty. 1
T — Corner Block — Qty. 12
Na — Large Side Stretcher / Medium Back
Stretcher — Qty. 3
U — 1/4"-20 x 2" Hex Bolt — Qty. 12
Oa — Medium Side Stretcher — Qty. 2
V — 1/4" Washer — Qty. 12
Pa — Small Back Stretcher — Qty. 1
Ra — Small Side Stretcher — Qty. 2
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED:
Padded Hammer or Mallet, 7/16" or Adjustable Wrench, Wood Glue
IMPORTANT!
WE RECOMMEND FINISHING THE UNIT BEFORE ASSEMBLY.
Before finishing, read enclosed finishing hints.
Small table shown
BACK LEG
BACK LEG
in all drawings.
L
L
K
J
Ra
Ra
FIG. 1
FIG. 1A
FRONT LEG
FRONT LEG
NOTE: COMPLETE STEPS 1, 2, & 3 FOR EACH TABLE BEFORE
PROCEEDING TO THE NEXT TABLE.
1) Note: Dowels in stretchers (Ra) are offset so be sure to assemble legs as shown above.
Apply glue to holes of Small Left Front Leg (J) and Small Back Leg (L). Attach legs to Small Side
Stretcher (Ra). See FIGURE 1. Repeat and attach small side stretcher to Small Right Front Leg
(K) and to Small Back Leg (L) as shown in FIGURE 1A.
447Wa (Rev. 2/07) — PAGE 3
Publicidad
