Whittier Wood Products 447Wa Instrucciones Para Armar página 4

2) Apply glue to holes of both leg assemblies. Attach both leg assemblies to the Small Back Stretcher
(Pa). See FIGURE 2.
NOTE: COMPLETE STEPS 1, 2 & 3 FOR EACH TABLE BEFORE
PROCEEDING TO THE NEXT TABLE.
U x 4
3) Place leg assembly on Small Top Assembly (C). Place a bead of glue across each end of the front
side of Corner Block (T). Attach with Hex Bolt (U) and Washer (V). Insert hex bolt into corner of leg
as shown in FIGURE 3. Lightly tighten bolts. Check alignment of side and back stretchers. Fully
tighten bolts.
4) Repeat steps 1 through 3 to assemble medium size table.
5)
Repeat steps 1 through 3 to assemble large size table.
PAGE 4 — 447Wa (Rev. 2/07)
J
L
FIG. 2
V x 4
T
FIG. 3
K
L
Pa
T
V
U
C