EN
This function puts the cooking process
on pause. The timer will also be
paused if it is activated.
Touch the Stop&Go sensor
one second. The pilot (9) lights up
and the power indicators will show
the symbol
to indicate cooking
has been paused.
Touch Stop&Go sensor
resumes under the same power and
timer settings that were established
before the pause.
This function supplies "extra" power
Said power depends on the size of the
the maximum value permitted by the
generator.
S l i d e t h e f i n g e r a b o v e t h e
corresponding cursor slider (2)
until the power indicator (3) shows
one second.
The power level indicator (3) will
show the symbol
will start to supply extra power.
The Power function has a maximum
adjust to 9. A beep sounds.
On activating the Power function in
performance of some of the others
displayed on its indicator (3).
be done either by means of touching
cursor "slider" modifying its power level
18
or repeating step 3.
This function facilitates cooking given
that you don't have to be present: You
(8) for
simultaneously program each plate
for durations ranging from 1 to 99
minutes.
(8) again.
Once the power level is set on the
will be able to be timed.
To that end:
Touch sensor
Timer Indicator (12) will show "00"
and corresponding zone indicator
(3) will show the symbol
alternately with its current power
level.
Immediately afterwards set a
cooking time between 1 and 99
ó
the second it will start at 01. By
keeping sensors
to 00. When there is less than one
count down in seconds.
. When the timer indicator (12) stops
the time automatically. The indicator
(3) relating to the timed hotplate
will alternately display the selected
power level and the symbol
Once the selected cooking time has
series of beeps for several seconds.
any sensor.The timer indicator (12)
the decimal dot (4) of the selected
alternately the H symbol and a "-".
If you wish to time another hotplate
If one or more zones are already
show by default the shortest remaining
related zone. Rest of timed zones will
show on their corresponding indicator
zones the decimal dot blinking. When
cursor "slider" of another timed zone
remaining time of that zone for a few
seconds and its indicator will show
its power level and the "t" alternately.
cursor "slider" (2) of timed zone has
to be pressed. Then it will be possible
to read and modify the time.
(10) or
(11).
Through sensors
you can modify the programmed time.
blinking
If you wish to stop the clock before the
done at any time by simply adjusting
its value to '--'.
(10)
Select the desired plate.
Adjust the value of the clock to "00"
(10) ó
(11)
by using the sensor
clock is cancelled. This can also be
done more quickly by pushing the
"sensors
same time.
Some models are equipped with
a power limiting function (Power
Management). This function allows
the total power generated by the hob
after having connected the hob to the
the power limiting menu.
Press the
three seconds. The letter PL will
(10) and
(10). The
(10) and
(11) at the
(11) touch key for