Kuppersbusch KE6130.1SE Instrucciones De Uso página 35

and all power display shows "L".
Warning : Child lock status is not being
child lock status could not be preserved.
Deactivating Child Lock :
Child Lock should be activated before
and all power display show "L"
1. (5) Increase power touch key
and (4) decrease power touch
key and minus sensors is hold for 3
seconds at same time. At the end of
2.
the (7) locking touch key (there
is no need to keep press for a long
time) and a long buzzer sound is
heard and the Child Lock will be
de activated and "Indication will be
Flash Cooking
(Automatic cook start)
This function facilitates cooking as
you do not need to be present while it
is being done. The touch control pre-
programmes the chosen hot plate at
the maximum power and subsequently
lowers it to the desired power level
(which you have selected) after an
approximate amount of time (see
table 1).
Table 1
Automatic Cook
Selected
Start
power
Function
0
1
2
3
4
5
6
7
8
9 ---/300
P (maximum)
SWITCHING THE AUTOMATIC
COOK START FUNCTION ON
1 The hot plate must be selected.
2 Select Power Function (P) and
then press power touch key
After using the touch key you must
lower the continuous cooking
example 6). When the automatic
cook function starts "A" indication
on the display.
SWITCHING THE AUTOMATIC
COOK START FUNCTION OFF
1 The hot plate must be selected.
2 Press touch key
indicator reaches level P and the
automatic cook start function will
be deactivated.
Timer Function
This function makes it easier to
present throughout the process:
automatically after the set time has
lapsed. There is a separate timer
all of the hot plates to be timed
simultaneously.
With these models you can use the
clock as a timer for the hotplates
for times ranging from 1 to 99
minutes. All the cooking areas can
be programmed individually and in
a simultaneous manner.
TIMING ONE HOTPLATE
0
1 The cooking zone to be timed must
60
be selected.
180
288
2 Select a power level for the
hotplate from 1 to 9 using the
390
touch keys
510
150
3 Press clock touch key
210
Timer indicator (12) will display
270
timed cooking surface indicator
---
4
a c o o k i n g t i m e b e t w e e n
(5).
using the touch keys or
When the power indicator (3) stops
time automatically. The respective
timed hotplate disolay (11) will
relevant power level and
alternately on the power indicator (3)
of the relevant heater area.
(5) till the
switch from counting down minutes
to seconds.
Once the selected cooking time has
timed is turned off and the clock
emits a series of beeps for several
seconds. The timer indicator will
display a flashing 00 beside the
hotplate that has been disconnected.
If you wish to time another hotplate at
If the heating zone turned off is
signal touch any sensor.
CHANGING THE PROGRAMMED
TIME
must press the touch key of the timed
hotplate (2) to select it and then the
clock
change the time.
DISCONNECTION OF THE TIMER
If you want to stop the timer before
the programmed time is up
or (5/4).
1 First select the hotplate and then
(10).
press clock touch key
2 Use the touch key
recude the time to 00. The clock
is cancelled.
(5/4).
(10). You may then read and
(10).
EN
will
(4) to
35