Kuppersbusch KE6130.1SE Instrucciones De Uso página 37

Only use the blade on the
ceramic surface, avoiding the
scraper casing coming into contact
with the glass because this could
scratch it.
U s e b l a d e s i n p e r f e c t
condition. Immediately replace the
blade if it is damaged in any way.
the scraper, withdraw the blade and
fig. 4
Using the scraper
Blade protected Blade unprotected
A pot or pan may become
stuck to the glass due to a product
having melted between them. Do
not try to lift the pot while the hot
plate is cold! This could cause the
glass break.
Do not step on the glass or
lean on it as it could break and
cause injury. Do not use the glass
as a surface for putting objects.
Küppersbusch reserves the right to
make changes to its manuals that it
affecting the product's essential
features.
Environmental
considerations
The symbol on the product
or its packaging means that this
product cannot be treated like
ordinary household waste.This
product must be taken to a recycling
collection point for electrical and
fig. 3
that this product is disposed of
correctly, you will avoid harming
the environment and public health,
which could happen if this product
is not handled properly. For more
detailed information about recycling
this product, please contact your
local authority, household waste
service or the store where you
purchased the product.
The packaging materials used are
environmentally-friendly and can
be recycled completely. Plastic
materials, like household waste, in
your local container.
If something does not work
perform the verifications specified
below.
The appliance does not work:
Ensure that the power cable is plugged
in.
The pot sticks to the glass:
If there is molten material between the
maximum power and try to separate
them.
Single Sensor Error :
If any of the sensors is active more than
and error code"F1" is showed. This error
of them is that there may be an object
Make sure that there is no any object on
a dry cloth. If error situation continue
Plural Sensor Error:
If more than 2 sensors are sensed at
and error code"F2" is displayed.
Potential root reasons of the
problem :
• There may be an object(pot...) or
from pot...) that cover more than 2
sensors
• Touch control location may exposure
more heat or steam (from oven
bottom of the hob...)
Please be sure that there is no any
glass is wiped with a dry cloth. If error
switch for 10 second.
FC Error:
Fc message on the control and the
the electronics. Let thestove cool for
a while.
EN
37