Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Alternative method :
After zone selection if timer touch
related timer will be cancelled.
Power Function
This function supplies "extra" power
value.
1
Select power 9 and then press
power touch key
(5).
2 The power level indicator (3) will
show the symbol
will start to supply extra power.
Stop&Go Function
This function puts the cooking
process on pause. The timer will also
be paused if it is activated.
Activating the Stop&Go function.
Touch the Stop &Go sensor
between 1-3 seconds.
indicators will show the symbol
to indicate cooking has been paused.
D e a c t i v a t i n g t h e S t o p & G o
function
Touch the "Stop&Go" sensor
between 1-3 seconds again.
cooking is resumed under the same
power and timer settings that were
established before the pause.
function is not deactivated within 10
function
If due to an error one or several
appliance will be automatically
disconnected after a set amount of
time (see table 2).
36
Table 2
Selected
power
0
1
2
3
4
5
6
7
8
9
P
if the glass surface temperature is not
dangerous for the user or an H if there
is a burn risk.
then switch it on again.
(7)
Keep the control panel of the
The power
heating areas clean and dry at all times.
In case of operating problems
or incidents not mentioned in this
manual, disconnect the appliance
and contact the Küppersbusch
technical service.
(7)
The
Recommendation for the
good use of vitroceramic
If this
* Pans with a smaller diameter than
the shown heating area are not
recommended.
* Do not slide pots and pans over the
glass as they may scratch it.
* Although the glass can withstand
knocks from large pots and pans
it.
* To prevent damage to the ceramic
slide the pots and pans over the
vessels clean and in good condition.
MAXIMUM
products containing sugar on the
OPERATION TIME
glass while the surface is hot as
(In hours)
these could damage it.
0
10
5
5
4
clean it using suitable products and
3
implements once it has cooled down.
2
This will make the job easier and avoid
2
the build-up of dirt Never use harsh
cleaning products or tools that could
2
equipment.
1
Light dirt not stuck to the surface can
be cleaned using a damp cloth and a
gentle detergent or warm soapy water.
use a special cleaner for ceramic hot
plates and follow the instructions on
to being burned repeatedly can be
removed using a scraper with a blade.
(1) and
Slight tinges of colour are caused by
pots and pans with dry grease residue
underneath or due to grease between
the glass and the pot during cooking.
These can be removed using a nickel
scourer with water or a special cleaner
sugar or food containing a lot of sugar
that have melted onto the surface
must be removed immediately using
a scraper.
Metallic sheens are caused by dragging
metal pots and pans over the glass.
They can be removed by cleaning
thoroughly using a special cleaner
hobs
you may need to repeat the cleaning
process several times.
Use the glass scraper carefully. The
blade could cause injury!
incorrectly, the blade could break
and a fragment could get caught
between the surrounding trim and
the glass. If this happens, do not try
to remove it using your hands,
carefully use tweezers or a knife
Try not to spill sugar or
Cleaning and maintenance
Warning:
If you use the scraper
Publicidad
