Grant GR150 Manual De Operación página 7

2.2.4. Immersion thermostats (for use with non Grant baths)
WARNING: The container on which the unit is mounted must have the necessary
mechanical, chemical and heat resistance.
Use of control unit with clamp
The clamp is fitted to the controller with the clamp at the rear of the controller and the clamp
fixing knob facing outwards.
Using the three M3 screws supplied, fit the clamp to the controller. With the clamp correctly
aligned with the controller, three holes in the clamp line up with three screw fixings in the base
of the controller.
Clamp the controller to the side of your vessel. Vessels can be used with a maximum wall
width of 30mm.
Take care not to overtighten the clamp if you are attaching it to a glass vessel.
CAUTION: When using the immersion thermostat above 60C, use a tightly fitting lid
around the controller. The purpose of the lid is to prevent vapours from the hot liquid
escaping to the atmosphere or being drawn into the controller with the cooling air. Hot
vapours should not be inhaled. The lid also improves the heat up rate and reduces
liquid evaporation.
2.2.5. Lids
FG5 for S5
Select the combination of holes on the lid that is suitable for the application.
17091 Version 12 - October 2009 75T
Page 5
www.grant.co.uk
GR150, GP200
Operating Manual