Trix ICE 3 Manual página 20

NMRA/DCC standards if a perfect programming
function is to be guaranteed. The use of an un-
suitable operating system does not give grounds
for complaint under our guarantee or warranty
obligations.
Programming table of the most important CVs
CV Designation
1 Locomotive address
2 Starting voltage
3 Acceleration time
4 Braking time
5 Top speed
6 Middle speed
8 Basic setting
17+18 Expanded
locomotive address
20
Meaning
DCC address of the locomotive
Changes the minimum speed
Value * 0.87 gives the time from shutdown to top speed
Value * 0.87 gives the time from top speed to shutdown
Speed of the locomotive at the top speed level
Speed of the locomotive at the middle speed level.
CV 6 must be less than CV 5
8 = Restore basic factory settings
Long address. CV 17 = higher-value bit,
CV 18 = lower-value bit.
Long address must be activated
in CV 29 / bit 5.
G We recommend that you always change just one
setting value and see what effect this has.
G CV 8 is an important CV. Writing the value "8" will
result in the complete component being reset to the
factory settings that applied at the time of delivery!
Area Factory setting
1 – 127 3
1 – 75 4
0 – 64 8
0 – 64 6
0 – 64 63
0 – 64 25
8 –
128 – 9999 0