Dreame H12 Dual Manual De Usuario página 7

Installation
EN
Installing the Handle
Insert the end of the handle vertically into the port on the top of the appliance as
indicated until you hear a click.
咔哒
Click
Note: To disassemble, extend a hard object into the hole on the back of the appliance to press contacts
and pull the handle upwards at the same time.
Installing the
Storage Box
Install the storage box onto the charging
base.
Note: To remove the support rod, extend a tool into the hole on the bottom of the mount to press contacts and pull the
rod upwards at the same time.
7 7
2
1
Installing the Accessory
Storage Mount
Insert the support rod vertically into the
storage mount until you hear a click.
咔哒
Click
Charging
1. Place the charging base against a wall on level ground and connect it to a
power source. Fully charge the appliance before first use.
2. Place the appliance on the charging base, the on the screen will light up to indicate
the charging status. When charging, the number on the display screen represents the
current battery level as a percentage. When the number reaches 100, the battery is
fully charged and the will turn off.
Note:
•
If no operation is performed within 10 minutes, the appliance will enter the sleep mode.
•
To extend the battery life time, the battery keeps cooling down for about one hour automatically after you
have used the appliance for a long time.
EN
8 8