Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
UNPACKING
See Figures 5 - 6.
This product requires assembly.
„ Carefully lift the parts from the carton and place on a
level work surface.
NOTE: Many of the Loose Parts are stored in the water
reservoir.
WARNING:
Do not use this product if any parts on the Loose
Parts list are already assembled to your product
when you unpack it. Parts on this list are not
assembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result
in serious personal injury.
„ Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
„ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
„ The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures ex-
plained in this manual.
„ If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not oper-
ate this tool until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create acces-
sories not recommended for use with this tool. Any
such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING:
Do not connect to power supply until assembly
is complete. Failure to comply could result in
accidental starting and possible serious
personal injury.
ASSEMBLING THE STAND
See Figures 7 - 8.
„ With the unit in the upright position, spread the legs of
the stand. Place stand on level ground.
„ NOTE: When positioning the stand make sure each leg
is spread fully outward to ensure the stand's stability.
LEG ASSEMBLY
ADJUSTABLE FOOT
11 — English
Fig. 7
Publicidad
