Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
CLEANING THE RAILS
During use, the rails will become dirty preventing the table
rollers from rolling smoothly. Be sure to wash off and wipe
clean the rails often.
CLEANING THE SAW
„ Unplug the saw and water pump.
„ Empty the dirty water from the water tray and replace
with clean water.
„ Reconnect the pump power cord and the rubber boot.
„ Run clean water through the saw flushing debris through
the tube and around the cutting wheel.
„ Remove sliding table.
„ Once the table has been removed, rinse the rails and
water tray, and water tray frame.
„ Empty dirty water from the water tray and dry off the tool.
„ Replace the drain cap. Tighten securely.
CLEANING THE SUBMERSIBLE PUMP
„ Unplug pump before handling or cleaning the pump.
„ Remove the front cover.
„ Using a small brush and/or water, clean any debris or
trash that is trapped on the inside of the pump.
NOTE: To maintain efficiency and extend the life of the
pump, check intake screen before use to make sure it
is clean.
„ Rinse filter with clean water.
If the pump will not run, try the following solutions:
„ Ensure that the intake screen is free of obstructions.
„ Make sure that the water hose isn't clogged or knotted.
„ Be sure the unit is plugged into a functioning power outlet
and the pump is plugged into the electrical plug.
„ Be sure there is adequate water in the water tank and that
the pump's water flow selector is set to "MAX".
NOTE: Do not handle the pump while it is connected to a
power source.
30 — English
Publicidad
