Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
„ When the cut is made, turn the saw off. Wait for the
cutting wheel to come to a complete stop before
removing any part of the material.
„ Move the sliding table away from the motor head and
turn paver over to make through cut.
To make paver for corners:
„ Measure paver and landscaping feature to determine how
much material needs to be removed and how much of an
angle is required for wall corner.
„ Using grease pencil and square, draw a mark from center
of brick to corner, marking all the way around the paver.
„ Place the material on the table and firmly against
the fence.
„ Make sure the material is clear of the cutting wheel before
turning on the saw.
„ Turn the on/off switch to the on position.
„ Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
„ Hold the material firmly against the miter guide and fence
and feed the material into the cutting wheel.
„ When the cut is made, turn the saw off. Wait for the
cutting wheel to come to a complete stop before
removing any part of the material.
„ Move the sliding table away from the motor head and
turn paver over to make through cut.
„ If stacking paver, knock off pavers' drop edge, turn paver
over and lay paver.
NON- THROUGH
CUT
Fig. 35
25 — English
MARK
DROP EDGE
REMOVED
THROUGH CUT
Fig. 36
FINISHED PAVER
Fig. 37
Publicidad
