Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
„ Loosen wheel guard knob by turning counterclockwise
and open the cutting wheel guard.
„ Place the wheel wrench on the arbor nut then slide the
6 mm hex wrench into the arbor.
„ Holding the hex wrench firmly to prevent movement, turn
the wheel wrench counterclockwise to loosen.
„ Remove the arbor nut and outer washer, leaving the inner
washer on the arbor.
WARNING:
If inner washer has been removed, replace it
before placing wheel on arbor. Failure to do so
could cause an accident since the wheel will not
tighten properly. Never use wheels that have open-
ings, grooves, or teeth on this tool.
„ Place the cutting wheel onto arbor with the arrows on
wheel going in the counterclockwise direction.
NOTE: Two water nozzles come installed on this product. Be
sure to install cutting wheel so that there is a water nozzle on
each side of cutting wheel with water ports facing the cutting
wheel. The outer water nozzle can be easily removed for
installation of cutting wheel. Check that outer nozzle outlet
hole has been reattached with water port facing toward the
cutting wheel.
„ Replace the outer washer. The double "D" flats on the
washers align with the flats on the arbor.
„ Replace the arbor nut on the arbor. Using wheel wrench
and arbor wrench, tighten arbor nut securely.
INSTALLING SPLASH GUARD ASSEMBLY
See Figures 16 - 18.
The splash guard on this saw is a two-part assembly.
POST
SCREW HOLE
WASHER
SCREW
REAR SPLASH
GUARD
Attaching rear splash guard:
„ Line up rear splash guard holes with screw hole and post
on back of cutting wheel guard, as shown.
„ Insert screw through washer and splash guard then thread
into screw hole.
„ Tighten securely. Be careful not to overtighten.
Attaching side splash guard:
„ Install side splash guard over the rear splash guard.
„ Insert post, located on side of cutting wheel guard,
through hole in side flap of guard.
„ Settle splash guard grooves over ridges in cutting wheel
guard.
„ Repeat with other side.
„ After assembly is complete, pull rear splash guard
outward so flaps rest over side splash guard.
POST
REAR SPLASH
GUARD
SIDE SPLASH
GUARD
Fig. 16
16 — English
RIDGE
HOLE
GROOVE
guard
SIDE SPLASH
Fig. 17
REAR SPLASH
GUARD
Fig. 18
Publicidad
