Kohler 10675-CP Guía De Mantenimiento página 10

Cap
DC Sensor
Connector
Retaining Nut
Solenoid
Connector
Pin
Diaphragm
Remove the Solenoid
Close the control stop valve (refer to the "Control Stop Valve
Operation" section).
NOTE: If the unit has not flushed since the stop valve was closed,
the inlet arm may still be pressurized. Use the manual flush button
to release pressure.
Use a 3/32" hex wrench to remove the setscrew from the cap.
Remove the cap.
Disconnect the DC sensor connector from the solenoid connector
by pulling the two connectors apart.
Temporarily store the cap and DC sensor assembly in a safe
place.
Use an adjustable wrench to remove the solenoid assembly from
the valve body by unscrewing counterclockwise until the solenoid
is free.
1108712-5-D
Setscrew
Solenoid
Assembly
Spring
Valve Body
10
O-Ring
Piston Cover
Piston
Kohler Co.