Publicidad
Idiomas disponibles
Idiomas disponibles
Maintaining your appliance
How to run a self-cleaning cycle
Select the length of time for the self-cleaning operation, eg. 3 hours.
1.
Touch Self Clean 2/3/5h once for a 3 hour clean time, twice for a 5 hour clean
time, or 3 times for a 2 hour clean time. (The default setting is 3 hours.)
2.
Touch START/SET to start the self-cleaning cycle.
The motor-driven door lock will engage automatically.
IMPORTANT: Both doors lock when you run a self cleaning cycle on either
oven.
NOTE
•
You will not be able to start a self-cleaning cycle if the Control Lockout
feature is activated or if the oven's temperature is too hot.
The oven doors lock automatically. The display will show the cleaning
•
time remaining. You cannot to open the oven doors until the temperature
drops to a safe/cool temperature.
•
The self-clean feature can be used in only one oven at a time. While one
oven is in self-cleaning mode, you cannot use the other oven for cooking.
3.
When the self-cleaning cycle is done, End will appear in the display and the
oven will beep 6 times.
How to delay the start of self-cleaning
1.
Touch Self Clean 2/3/5h.
Select the desired self-clean time by touching Self Clean 2/3/5h.
2.
Touch Delay Start.
3.
Enter the time you want the self-clean cycle to start.
4.
Touch START/SET.
The display will show Delay, Self clean, and the Lock icon. The motor-driven
door lock will engage automatically.
5.
The Self-Cleaning cycle will turn on automatically at the set time.
52 English
NQ70M6650DS_AA_DE68-04446A-00_EN.indd 52
How to turn off the self-cleaning feature
If you need to stop or interrupt a self-cleaning cycle:
1.
Touch OVEN OFF.
2.
You will be able to open the oven door once the oven has cooled down for
approximately 1 hour.
After a self-cleaning cycle
•
You may notice some white ash in the oven. Wipe it up with a damp cloth
after the oven cools. (If white spots remain, remove them with a soap-filled
steel wool pad and rinse thoroughly with a vinegar and water mixture.)
•
If the oven is not clean after one cycle, repeat the cycle.
•
You cannot set the oven for cooking until the oven is cool enough for the door
to unlock.
Hybrid Cleaning (lower oven only)
The Hybrid cleaning function saves time and energy by removing leftover grease
and residue that you can then wipe away with a damp cloth.
CAUTION
•
Do not line the oven walls, racks, bottom, or any other part of the oven with
aluminum foil. Doing so will result in poor heat distribution, poor baking
results, and cause permanent damage to the oven interior. Aluminum foil will
melt and adhere to the interior surface of the oven.
•
The oven door locks during Hybrid cleaning. Do not force the oven door open.
This can damage the automatic door locking system. Use care when opening
the oven door after a Hybrid Cleaning cycle is complete. Stand to the side of
the oven when opening the door to allow hot air or steam to escape.
2017-01-05
6:16:12
Publicidad
