JVC GR-D875U Manual De Instrucciones página 22


Recording & Playback
EN
Notes:
• The playback picture can be viewed in the LCD
monitor or on a connected TV ( 41).
• If Stop mode continues for 5 minutes
when power is supplied from a battery, the
camcorder shuts off automatically.
• When a cable is connected to the AV
connector, the sound is not heard from the
speaker.
HDV
Appears when pictures recorded in the HDV
format are detected. The pictures in the
HDV format cannot be played back with this
camcorder.
Variable Shuttle Search
Allows variable-speed search in either
direction during video playback.
During playback, press
for forward search, or
reverse search.
3
x-10 x-3
To resume normal playback, press U/ 9.
•
• During playback, press and hold 5 or
3. The search continues as long as you
hold the button. Once you release the button,
normal playback resumes.
Attention:
During Shuttle Search,
parts of the picture may
not be clearly visible,
particularly on the left
side of the screen.
During Shuttle Search,
parts of the picture may
not be clearly visible
across the screen.
once or twice
5
once or twice for
3
5
x3 x10
Blank Search
Helps you find where you should start
recording in the middle of a tape to avoid time
code interruption ( 20).
1
1 Perform steps
( 21).
2 Press BLANK.
• The "BLANK SEARCH" indication
appears and the camcorder
automatically starts reverse or forward
search, then stops at the spot which
is about 3 seconds of tape before the
beginning of the detected blank portion.
• To cancel Blank Search, press 8 or
BLANK.
Notes:
• Before starting Blank Search, if the current
position is at a blank portion, the camcorder
searches in the reverse direction. If the
current position is at a recorded portion, the
camcorder searches in the forward direction.
• If the beginning or end of the tape is reached
during Blank Search, the camcorder stops
automatically.
• A blank portion which is shorter than
5 seconds of tape may not be detected.
• The detected blank portion may be located
between recorded scenes. Before you start
recording, make sure there is no recorded
scene after the blank portion.
3
- in "Normal Playback"