JVC GR-D875U Manual De Instrucciones página 44


Connections/Editing
EN
Audio Dubbing
The audio track can be customized only when
recorded in the 12-BIT and SP modes ( 31).
• Use the provided remote control.
START/
STOP
PAUSE
PLAY
REW
STOP
INSERT
A.DUB
1
Play back the tape to locate the point
where editing will start, then press
PAUSE (8).
2
While holding A. DUB (D) on the remote
control, press PAUSE (8). The "8D"
indicator appears.
3
Press PLAY (3), then begin "narrating".
Speak into the microphone.
• To pause dubbing, press PAUSE (8).
4
To end Audio Dubbing, press PAUSE (8),
then STOP (7).
To hear the dubbed sound during playback
Set "NARRATION" to "ON" or "MIX"
( 29, 34).
Notes:
• Sound is not heard from the speaker during
Audio Dubbing.
• When editing onto a tape that was recorded
at 12-BIT, the old and new soundtracks are
recorded separately.
• If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only
edit recorded areas.
• If feedback or howling occurs during TV
playback, move the camcorder's microphone
away from the TV, or turn down the TV's
volume.
You can record a new scene into a previously
recorded tape, replacing a section of the
original recording with minimal picture
distortion at the in and out points. The original
audio remains unchanged.
• Use the provided remote control.
Notes:
• Before performing the following steps, make
Microphone
• Insert Editing is not possible on a tape
1
2
3
4
• Confirm the insert at the time code you
• To pause editing, press START/STOP.
5
Notes:
• Program AE, Effects and Shutter Effects
• During Insert Editing, the date and time
• If you perform Insert Editing onto a blank
• During Insert Editing, when the tape moves
Insert Editing
sure that "TIME CODE" in both Recording and
Playback Menus is set to "ON". ( 29, 34).
recorded in the LP mode or on a blank portion
of a tape.
Play back the tape, locate the Edit-Out
point and press PAUSE (8). Confirm the
time code at this point ( 20).
Press REW (1) until the Edit-In point is
located, then press PAUSE (8).
Press and hold INSERT (I) on the remote
control, then press PAUSE (8). The "8I"
indicator and the Time Code (min.:sec.)
appear and the camcorder enters Insert-
Pause mode.
Press START/STOP to begin editing.
1
checked in step .
Press it again to resume editing.
To end Insert Editing, press START/STOP,
then STOP (7) on the remote control.
( 39) can be used to spice up the scenes
being edited during Insert Editing.
information changes.
space on the tape, the audio and video may be
disrupted. Make sure you only edit recorded
areas.
to scenes recorded in the LP mode or a blank
portion, Insert Editing stops.