RIDGID RP 342-XL Manual página 12

RP 342-XL Press Tool RP 342-XL Press Tool
1). Any time release button is depressed, press is
NOT complete and the connection must be pressed
again to ensure completion. If the tool malfunctions
during operation, use this procedure. In case of emer-
gency, release run switch and depress release button.
Figure 11 – Installing Press Ring Onto Fitting
Figure 12 – Attaching Actuator to Press Ring
5. Release the run switch.
6. Squeeze actuator arms to open actuator. Remove
actuator from fitting.
7 . Remove ring from fitting. Avoid sharp edges that may
have formed on fitting during pressing operation.
8. When operation is complete, depress ON/OFF button
one time to turn tool OFF. Remove battery from tool.
Inspecting The Pressed Connection
1. Inspect the pressed fitting for:
• Full insertion of tube into fitting.
• Excessive misalignment of the tubes. A slight
amount of misalignment at a pressed connection
is considered normal.
• Incorrect attachment alignment with the fitting con-
tour. Distorted or deformed fitting.
10
• Any other issues per the fitting manufacturer. This
could include the removal of a control ring or decal
(used to indicate the connection has not yet been
pressed).
If any issues are found, remove fitting and install a
new connection.
2. Test connection in accordance with fitting manufactur-
er instructions, normal practice and applicable codes.
Storage
Remove battery from tool. Store press tool and battery in
case. Avoid storing in extreme heat or cold. The tool will not
turn ON if the tool is outside the specification range. This
will be indicated by the tool status lights. (See Figure 5.)
Store tool in a dry, secured, locked area
WARNING
that is out of reach of children and people unfamiliar with
the Press Tools. The tool is dangerous in the hands of
untrained users.
Maintenance Instructions
WARNING
Make sure battery is removed from tool before per-
forming maintenance or making any adjustment.
Cleaning And Lubrication
1. Wipe the tool clean daily with a clean dry cloth.
2. Inspect the attachment mounting pin and lubricate the
pin with silicone lubricant as needed.
3. Check return springs in attachments with each use.
Attachments should open and close freely with only
moderate finger effort required.
Required Maintenance By RIDGID
Authorized Independent Service Center
The RP 342-XL Press Tool must be serviced at set in-
tervals by a RIDGID Authorized Independent Service
Center to ensure proper operation. This will be indicated
by a tool status light (See Figure 5).
Service And Repair
WARNING
Improper service or repair can make machine
unsafe to operate.
Service and repair on the RP 342-XL Press Tool must be
performed by a RIDGID Authorized Independent Press
Tool Service Center.
999-999-207.10_REV. B