RIDGID RP 342-XL Manual página 7

mercially available Extended Series Press attachments
(See Specifications section) approved by RIDGID for use.
The press cycle for Standard Series attachments is
approximately 4 seconds, and for Extended Series at-
tachments it is approximately 9 seconds. Once the cycle
begins to deform a fitting, it will automatically continue
until completion, even if the run switch is released.
The Tool Status Lights indicate things such as out of
specification temperature, low battery, or maintenance
required. A work light turns on when the run switch is
depressed to illuminate the work area.
The head can be rotated 270° for better access in tight
spaces.
The tool comes with two (2) fabric loops that can be used
with appropriate attachments such as shoulder straps or
tie off lines.
ON/OFF
Fabric
Tool Status
Button
Loop
Lights
Pressure
Release
Button
Warning
Labels
Handle
Figure 1 – RIDGID RP 324-XL Press Tool and Standard
Series Jaw
Control
On/Off Button
Run Switch
Pressure Release Button
Attachment Mounting Pin
Sleeve - Extended (80 mm)
Series Configuration
Sleeve - Standard (40 mm)
Series Configuration
Figure 4 – Controls Chart
999-999-207.10_REV. B
Attachment
Mounting
Sleeve
Housing
Pin
Work
Light
Run
Switch
Battery
Marking Description
Main tool power switch. Press to turn ON/OFF.
ON: Press button until light turns ON. See Figure 5 – Tool Status Lights.
OFF: Press button until light turns OFF. Tool will automatically turn OFF if left
unused for ten (10) minutes.
Depress to press fittings. Release when tool locks on. Releasing the switch will
— not stop the tool once it has locked on. This assures consistent, repeatable press
connection integrity.
Allows tool to be released without completing press. If used, press connection is not
complete and must be repeated.
— Holds attachment to tool. See Figure 6.
Extended
Sleeve slides between Extended and Standard configurations for use with
80 mm
appropriate attachments. see Changing Tool Configuration (Extended (80 mm)/
Standard
Standard (40 mm)).
40 mm
RP 342-XL Press Tool RP 342-XL Press Tool
Warning Label
Figure 2 – ON/OFF switch and Tool Status Lights
- -
27.2
490 32 k
20XX
Figure 3 – Machine Serial Number - The circled digits
indicate the month (MM) and year (YY) of man-
ufacture.
ON/OFF Button
Tool Status Lights
5