RIDGID RP 342-XL Manual página 13

Troubleshooting
SYMPTOM
Tool will not turn ON
when ON/OFF button is
pressed.
Attachment is locked
onto fitting.
The pressed connections
produced are not com-
plete.
Oil leaks from tool.
Motor runs but tool will
not complete a cycle.
Tool stops during
operation.
See Figure 5 – Tool Status Lights
For information on your nearest RIDGID Authorized In-
dependent Service Center or any service or repair ques-
tions see Contact Information section in this manual.
Optional Equipment
WARNING
To reduce the risk of serious injury, only use equip-
ment specifically designed and recommended for
use with the RIDGID RP 342-XL Press Tool, such as
listed below.
Battery and Adapter Packs
Catalog
No. Description
56513 RB-1825 18V 2.5 Ah Lithium Ion Battery
56518 RB-1850 18V 5.0 Ah Lithium Ion Battery
44468 120 AC Power Adapter – North America
Chargers and Cords
Catalog
No.
64383 RBC-30 Charger
64173 RBC-30 Charger Cord
999-999-207.10_REV. B
POSSIBLE REASONS
Battery is completely discharged or battery has
failed.
Battery not properly inserted into handle of tool.
Press was not successfully completed.
Used wrong attachment for the tube size or ma-
terial.
The tool was not square to the tube.
Attachment press profile was not aligned with the
fitting contour.
Tool is in need of repair.
Seal or mechanical problems.
Oil level low.
Oil level low.
Plug
Region Type
North America A
North America A
RP 342-XL Press Tool RP 342-XL Press Tool
SOLUTION
Insert fully charged battery/recharge battery.
Check to assure battery is fully inserted.
Push pressure release button to remove jaws from
fitting. Inspect and repress fitting.
Install the correct attachment.
Redo the joint with new fitting and new tube. Make
sure that the tool is square to the tube.
Redo the joint with new tube and new fitting. Make
sure the press profile is aligned with the fitting
contour.
See Contact Information for nearest RIDGID
Authorized Inde pendent Service center.
See Contact Information for nearest RIDGID
Authorized Inde pendent Service center.
Ridge Tool Company provides Standard series press
attachments designed specifically for use with RIDGID
Standard Press Tools. Only use attachments that are
specifically designed to press the fitting system you are
installing.
For a complete listing of RIDGID equipment available for
these tools, see the Ridge Tool Catalog online at RIDGID.
com or see Contact Information.
Disposal
Parts of these tools contain valuable materials and can
be recycled. There are companies that specialize in
recycling that may be found locally. Dispose of the com-
ponents in compliance with all applicable regulations.
Contact your local waste management authority for more
information.
For EC Countries: Do not dispose of electri-
cal equipment with household waste!
According to the European Guideline 2012/
19/ EU for Waste Electrical and Electronic
Equipment and its implemen tation into na-
tional legislation, electrical equipment that
is no longer usable must be collected separately and
disposed of in an environmentally correct manner.
11 11