cecotec HYDROBOOST 2500 HOME&CAR Manual De Instrucciones página 13

repair or replace damaged or worn parts immediately.
- Use only original spare parts supplied or recommended by
Cecotec to ensure safe operation.
- Use only the nozzle included with the product.
- Do not leave the high pressure hose unattended while the
device is operating.
- Hold the high pressure hose and gun firmly when switching
on and while using the machine.
- Do not leave the unit running with the trigger released for
more than one minute, this could damage the pump.
- This device is not designed to pump hot water. Do not
- Make sure the water inlet pressure is between 0.01 MPa and
0.4 MPa and that the inlet hose is at least 5 metres long.
- If the device is to be connected to a drinking water supply,
install a disconnector on the water pipe to prevent dirty
water from backing up and entering the drinking water
system. The disconnector shall comply with EN 60335-2-79
ANNEX A.
- Water that has flowed through backflow prevention devices
is considered non-drinkable.
- This device must not be controlled by external switching
elements such as timers, or connected to electrical circuits
that are continuously switched on and off.
- Release the trigger when switching from high to low
pressure.
- Setting the nozzle.
connect to a hot water supply as this will
significantly reduce the shelf life of the pump.
This symbol means that this device is not
-
suitable to be connected to drinking water
sources.
HYDROBOOST 2500 HOME&CAR
13