cecotec HYDROBOOST 2500 HOME&CAR Manual De Instrucciones página 68

ENGLISH
EasyClean brush special for joints.
This model also includes a cleaning brush which, combined with water and soap, helps
remove stains and allows for a more efficient cleaning. When using this accessory, water will
automatically come out as spray, at low pressure.
2-spin brush special for floors.
This accessory is installed on the wand of the product and consists of hard bristles. When
activated, it rotates while emitting water at high pressure, making thorough cleaning possible
in the most convenient way. It is designed to clean the patio, garden floor or floors in general.
Fig. 9
Note
- This is a wand accessory, they do not fit the gun, to fit them push them in and then turn to
lock.
- Before using the 2-spin brush, you must check it will not damage the surface to be cleaned
by testing it on an inconspicuous place.
- Do not try to assemble accessories while the pressure washer is on.
Cleaning process
The following cleaning procedure will help you organise and ensure you get the best results.
Remember to follow the previous advice.
Preparing the surface
- Clear the area of furniture and check that windows and doors are securely closed.
- Also make sure that plants and trees near the area to be cleaned are protected with a cloth.
Initial high-pressure rinse
Spray the area to be cleaned with water to clean any dirt that may have accumulated on the
surface. Start with the nozzle with less pressure and progressively increase it until reaching
the desired jet power. In this way, you will avoid applying an excessively direct jet on more
delicate surfaces.
Using soap
Water and soap must be used with these percentages: 5.4% soap, 94.6% water (1:19).
Warning
Use only soaps designed for pressure washers.
- Test the soap in an inconspicuous place before using the product.
- Loosen the cap of the soap bottle and fill it with water and soap.
HYDROBOOST 2500 HOME&CAR
68