Norwood LumberMax HD38 Instrucciones Originales página 19

Vertical Motor Wiring
HD3X-5000-INST (2022-08-18).indd 15 HD3X-5000-INST (2022-08-18).indd 15
Run the 116" (295 cm) cable (19) down
the rear leg.
Connect the 116" (295 cm) cable (9)
with the drive motor using the splice
connector.
Red motor cable with red cable and
black with black.
Plug the male connector of the 32" (81
cm) vertical motor cable (20) to the
proper female plug (see control panel
diagram).
Run the 32" (81 cm) cable (20) up
along the push handle and connect it
to the vertical motor using the splice
connectors. (red wire with red wire and
black with black).
NOTE: The green wire is not needed.
EN–15
2022-08-18 12:21:13 PM 2022-08-18 12:21:13 PM