Norwood LumberMax HD38 Instrucciones Originales página 6

e. Are not taking medication that can impair judgment,
reaction times, mobility, alertness or otherwise cause
negative side effects.
Persons who fail to meet any of these requirements are
not qualified to use the equipment or handle blades.
Wear protective gloves when working with the
equipment or handling blades. Risk of cutting
injuries when handling blades. Blades and
engine can be hot immediately after sawing.
Wear approved hearing protection when
operating the equipment. Hearing can
be permanently impaired after only short
exposure to high-frequency sounds.
Wear approved close-fitting safety goggles
when working with the equipment or handling
blades.
Wear approved protective footwear with saw
protection, steel toe-cap and non-slip sole
when working with the equipment or handling
blades.
Wear full-length protective pants when working
with the equipment or handling blades. Never
wear loose-fitting clothing, scarves, jewelery
or similar long items that can get caught when
working with the equipment. Always secure loose hair
before working with the equipment.
Box Contents
Item Qty.
HD36-5000 BOX #1 (Power Sawhead Box #1 - Drive) (18" x 15" x 11") (36 lb)
Carriage Drive Assembly (factory-assembled):
2 2 1/2" x 1 1/2" bolt - shoulder bolt
7 4 1/4" x 3/4" bolt - fine thread hex head
8 5 #10 - 24 x 3/4" screw - Phillips round-head screw
9 2 3/8" nut - flanged (regular)
10 1 3/8" nut - flanged nylon lock nut
15 1 3/8" x 3/4" bolt - flanged bolt (regular)
2 Disconnect - Male - 0 .250 - 12 to 10 GA
29 1 Power sawhead (LM34) - Drive cover
30 1 Power sawhead (LM34) - Drive motor bracket
31 1 Power sawhead (LM34) - Drive motor mount bracket
33 1 Power sawhead (LM34) - Motor - Drive (forward/reverse)
37 1 Sprocket - Drive sprocket - 35B24F x 3/4" bore tsubaki
38 2 Sprocket - Idler sprocket - 35BB19 x 1/2" bore martin
EN–2
HD3X-5000-INST (2022-08-18).indd 2 HD3X-5000-INST (2022-08-18).indd 2
Wear respiration protection when working
with the equipment. Long term inhalation of
sawdust and the engine's exhaust fumes can
represent a health risk.
Always stay behind the sawhead after the engine
has started.
Review and follow all of the safety instructions in the
sawmill manual and in the engine manual.
Do not move the sawmill carriage without the cover
of the control panel properly installed or without the
drive cover (29).
Do not exceed the operational limitations of the
system. Doing so can cause an accident or injury.
Pinch hazard. Risk of injury from exposed chain.
Keep clear.
Before each use, check for electrical wire damage
and replace if necessary.
Description Norwood No.
FASB-12112SB
FASB-1434FH
FASS-31634
FASN-38RFL
FASN-38LNF
FASB-3834F
LM34-DM1
LM34-PS-104
LM34-PS-101
LM34-PS-123
LM34-PS-003
LM34-PS008
LM34-PS009
2022-08-18 12:21:07 PM 2022-08-18 12:21:07 PM