Publicidad
Idiomas disponibles
Idiomas disponibles
Dust bag
CAUTION:
When performing a cutting, always
attach the dust bag or connect a vacuum cleaner
to prevent dust-related hazards.
The use of the dust bag makes cutting operations clean
and dust collection easy. To attach the dust bag, con-
nect the dust bag to the dust nozzle.
Fig.34
► 1. Dust bag 2. Dust nozzle
When the dust bag is about half full, remove the dust
bag from the tool and pull the fastener out. Empty
the dust bag of its contents, tapping it lightly so as to
remove particles adhering to the insides which might
hamper further collection.
1
Fig.35
► 1. Fastener
2
1
Securing workpiece
WARNING:
secure the workpiece correctly with the proper
type of vise. Failure to do so may result in serious
personal injury and cause damage to the tool and/or
the workpiece.
WARNING:
raise the saw blade until it has come to a com-
plete stop. The raising of a coasting saw blade may
result in serious personal injury and damage to the
workpiece.
WARNING:
longer than the support base of the miter saw, the
material should be supported the entire length
beyond the support base and at the same height
to keep the material level. Proper workpiece support
will help avoid blade pinch and possible kickback
which may result in serious personal injury. Do not
rely solely on the vertical vise to secure the work-
piece. Thin material tends to sag. Support workpiece
over its entire length to avoid blade pinch and possi-
ble KICKBACK.
1
Fig.36
► 1. Support 2. Turn base
Guide fences
WARNING:
sure that the sliding fence is secured with the
clamping screw firmly.
WARNING:
that no part of the tool, especially the circular
saw blade, contacts the fences when fully low-
ering and raising the handle in any position and
while moving the carriage through its full range
of travel. If the tool or circular saw blade makes
contact with the fence, this may result in kickback or
unexpected movement of the material and serious
personal injury.
17 ENGLISH
It is extremely important to always
After a cutting operation, do not
When cutting a workpiece that is
2
Before operating the tool, make
Before bevel-cutting, make sure
Publicidad
