Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Square the side of the saw blade with the face of
the guide fence using a triangular rule or try-square.
Then securely tighten the hex socket bolts on the guide
fence in order from the right side.
1
Fig.52
► 1. Guide fence 2. Triangular rule
5.
If the pointer does not point to 0°, loosen the
screw which secures the pointer and adjust the pointer
so that it points 0°.
1
2
3
Fig.53
► 1. Screw 2. Pointer 3. Miter scale
Bevel angle
0° bevel angle
1.
Lock the carriage in the lowered position by the
stopper pin. Push the carriage toward the guide fence
and tighten the thumb screw to secure the carriage.
2.
Loosen the lever. Then turn the 0° adjusting bolt
two or three revolutions counterclockwise to tilt the
circular saw blade to the right.
1
2 2
2
Fig.54
► 1. Lever 2. 0° Adjusting bolt
3.
Carefully square the side of the saw blade with
the top surface of the turn base using the triangular
rule, try-square, etc. by turning the 0° adjusting bolt
clockwise. Then tighten the lever firmly to secure the 0°
angle you have set.
Fig.55
► 1. Triangular rule 2. Saw blade 3. Top surface of
turn base
4.
If the pointer does not point 0°, loosen the screw
which secure the pointer and adjust it so that it points 0°.
1
2
3
Fig.56
► 1. Screw 2. Pointer 3. Bevel scale
27 ENGLISH
1
2
3
Publicidad
